Washington State Department of Labor & Industries
Ehstoday 7926 Sierra Pacific

Fatal Fall Investigation Results in Citation and Fine for Aberdeen Lumber Mill

Oct. 26, 2017
An Aberdeen lumber mill has been fined $112,000 for safety violations following the death of a worker last April.

Andrew Ward, 41, an employee at Sierra Pacific Industries in Aberdeen, Wash., died when he fell from an elevated platform where he was working to the concrete surface below. An investigation by the Washington State Department of Labor & Industries (L&I) resulted in citations for Sierra Pacific Industries for seven safety violations at the lumber mill where the incident happened.

L&I’s investigation found that a section of permanent yellow guardrail was removed from the 17-and-a-half-foot-high platform and replaced with yellow caution tape so that a crane could move some equipment. When Ward went to the edge of the platform to communicate with the crane operator below, he leaned forward and fell.

“A death like this is especially tragic because it was completely preventable by using proper fall protection and following safe work practices,” said Anne Soiza, L&I’s assistant director for the Division of Occupational Safety and Health. “Falls are the leading cause of worker deaths and immediate hospitalizations. Employers need to be vigilant about preventing falls.”

The investigation found that the employer knew that caution tape cannot be used in place of guardrails at a high elevation, but still regularly allowed it to happen. Additionally, the employer was required to provide workers with a fall protection system, such as a harness, lanyard and tie-off point, while working on the elevated platform without adequate guardrails, and when removing them.

As a result, Sierra Pacific has been cited for a willful violation, the most serious, with the maximum penalty of $70,000 for not ensuring that an open-sided work platform was adequately guarded and for not ensuring employees wore fall protection equipment.

The employer was cited for an additional six serious violations, each with the maximum penalty of $7,000. Those violations covered a range of serious hazards that exposed workers to harm, including ineffective safety and health training; a safety program that wasn’t tailored to company operations; inadequate personal protective equipment training; untrained crane personnel; and not following safety precautions required for open flame work.

Because of the willful violation that led to the death of a worker, Sierra Pacific Industries has been placed on the severe violator list and will be subject to follow-up inspections to determine if the conditions still exist in the future.

The company has appealed the violations.

Sponsored Recommendations

ISO 45001: Occupational Health and Safety Management Systems (OHSMS)

March 28, 2024
ISO 45001 certification – reduce your organizational risk and promote occupational health and safety (OHS) by working with SGS to achieve certification or migrate to the new standard...

Want to Verify your GHG Emissions Inventory?

March 28, 2024
With the increased focus on climate change, measuring your organization’s carbon footprint is an important first action step. Our Green House Gas (GHG) verification services provide...

Download Free ESG White Paper

March 28, 2024
The Rise and Challenges of ESG – Your Journey to Enhanced Sustainability, Brand and Investor Potential

Free Webinar: Mining & ESG: The Sustainability Mandate

March 28, 2024
Participants in this webinar will understand the business drivers and challenges of ESG and sustainability performance, the 5 steps of the ESG and sustainability cycle, and prioritized...

Voice your opinion!

To join the conversation, and become an exclusive member of EHS Today, create an account today!