Facing the Unthinkable: Fatality Prevention in the Workplace

Jan. 1, 2008
No employer, family member or coworker ever wants a fatality to occur in the workplace. But it happens. In 2006 alone, 5,703 people died on the job, representing

No employer, family member or coworker ever wants a fatality to occur in the workplace. But it happens. In 2006 alone, 5,703 people died on the job, representing a multitude of poor choices and system failures that might have been avoided with better information or preparation.

Preventing workplace fatalities is the indisputable goal of any safety management system, but too often, the system breaks down. Employers fail in their leadership roles, well-meaning safety managers approach fatality prevention from the wrong direction or employees develop feelings of invincibility and the unthinkable occurs: someone dies on the job.

Indiana University of Pennsylvania (IUP) and the Alcoa Foundation hosted an event last November to establish a dialogue about occupational deaths. The two-day Fatality Prevention in the Workplace Forum, which attracted more than 150 safety professionals and industry leaders, was the starting point for a discussion of the causes of fatalities, the best ways to prevent them and suggestions for future areas of research.

Occupational Hazards spoke to some key presenters from the forum to determine exactly what companies, safety professionals and employees should be doing to prevent the unthinkable.

Frequent vs. Fatal

Fred A. Manuele, president of Hazards Limited, presented his research on workplace fatalities and serious injuries at the IUP forum. One of the biggest myths he set out to discredit is that reducing frequently occurring injuries also will prevent serious or fatal incidents.

Manuele says this approach “has been proven untrue” and stresses that fatal incidents often occur during non-routine tasks, the type safety professionals may have the least experience dealing with. And even if a company has a stellar safety history when it comes to serious incidents, it can be risky to take comfort in rates.

“You should not be deluding yourselves that you don't have serious injury potential just because your rates are down,” Manuele warns.

Lon Ferguson, chair of the IUP safety sciences department and a key organizer of the fatality forum, agrees that injury rates can be misleading or can create false reassurance. He particularly questions the fact that total recordable rates seem to be decreasing across the board, but fatality rates aren't following suit at the same pace.

“Why isn't there more of a relationship?” Ferguson asks. “The fact is that it's very difficult to hide fatality data, but you can play games with rates.”

While Ferguson isn't suggesting that dishonest rate reporting is a widespread problem, he acknowledges the possibility. “Someone has to at least think about that as a possible option,” he says. After all, Ferguson explains, companies are under pressure to get their injury rates down — and keep them down.

Jeff Shockey, corporate safety director for Alcoa, points out the risks associated with relying too heavily on a successful safety past. “It's easy to sit back and feel good about total recordable rates, or OSHA compliance, or having passed the last ISO audit, and be lulled into a sense of overconfidence,” he says. “But fatalities are a different animal. They don't care if you have the lowest total recordable rate.”

To prevent fatalities, Manuele thinks safety professionals must be willing to change the way they look at incident prevention. “They have to change the philosophy that says what we have in place is adequate,” he says. He also debunks the myth that worker causes are the principle contributors to fatal incidents. In reality, he believes “the system is the problem, not the worker.”

What exactly is wrong with the system? According to these experts, economic and investment pressures, turnover, leadership, global competition and downsizing play big roles in the likelihood of workplace fatalities.

A Fatal Environment

Manuele says that non-routine work, upsets in regular work, non-production capacities and work involving sources of high energy make up the situations most likely to lead to fatal incidents.

Other contributing factors also influence the risk of fatal and severe incidents:


Ferguson explains that a lack of senior management ownership and the failure to hold safety as a core value can chip away at safety management systems. And as many safety professionals know, these breakdowns can lead to fatalities. “Sometimes leadership doesn't realize the impact on safety culture,” he says.


If a leader only is with the company for a few years, he or she has time to make decisions that will impact safety without being there long enough to see the consequences of those decisions. Employee turnover also contributes to the problem. Workers who stay with a company long term absorb the culture, including safety practices, but today's more transient environment eliminates that benefit.

Employee-Employer Ratio

Shockey points out that the ratio of employees to employers is increasing in many companies. Picking up extra work — and extra employees — means leaders and managers have a larger span of control. It also means limited time for them to mentor, teach and observe their employees, which could contribute to deadly workplace situations.

And, as is common with many factors that contribute to organizational breakdown, economic issues are often to blame.

Economic Pressure

When companies downsize and grow leaner, safety inevitably takes a hit. Manuele explains that these companies feel they are running short — so short, in fact, that they don't have enough staff to maintain the organization, much less a safety program. As companies are expected to churn out faster and cheaper production, it can create an atmosphere rife with the possibility of severe injuries or fatalities.

“[Forum] participants indicated the shift in focus where production takes a priority over safety seems to be occurring on a more routine basis,” Shockey explains. “The globally competitive nature of world economy really puts pressure on folks to do more with less — less money, less people, less resources.”

Shareholders and stakeholders also have an impact on the likelihood of fatalities. “It appears investors are looking at the short-term focus and are primarily profit-oriented,” Shockey says.

He adds that in some cases, environmental managers receive incentives while the safety department is left out in the cold. “[Shareholders] want to see companies controlling costs and want them to be green. As a result, fatality prevention often competes with cost reduction and the environmental focus,” he continues. “Our profession has begun to ask: Where's the tax incentive for protecting people, as compared to environmental tax incentives for industry?”

Who's at Risk

By identifying the employees most likely to be involved in a fatal or serious incident, safety professionals can target their efforts to the employees who need appropriate training or education.

New Employees

“People new to the job have a fairly high risk profile,” Shockey says. Developing a comprehensive new employee orientation process and focusing training on life-threatening risks could have a positive impact on fatality prevention.


Contractors also are at a higher risk to be involved in a serious or fatal incident. While many contractors may have excellent safety records, Shockey points out that “generally speaking, anytime contractors are on a plant site, it increases the risk.”

After surveying forum participants, Chris Janicak of IUP found that contractors who do not work under the employer's watchful eye especially face an increased risk for fatalities. “A lot of the fatalities involved contractors that were not under [the employer's] supervision,” he reveals.

Outsourced/Temporary Employees

Outsourcing employees or using temporary manpower means employing people who are not familiar with either the processes or the risks inherent in the job.

Workers Logging Overtime

Employees who work more hours trade off the benefit of added production with fatigue and an increased likelihood of incidents.

Risk Takers

Industries with a history of tolerating risk-taking cultures, Ferguson explains, attract risk-taking employees. Even worse, Ferguson says the presence of both “internal and external rewards for risk-taking” can affect safety processes. Employees actually may be most vulnerable when they feel invincible.

Best Practices to Prevent Fatalities

In light of all these risks and contributing factors, protecting employees from fatal and serious incidents is clearly a challenge. Of course, no one said it wouldn't be complicated.

“Safety professionals are trying to get ahead, trying to learn to predict where the vulnerabilities are — it's not an easy task,” Shockey admits.

Here are a few ways employers and safety professionals can start to tackle the task of achieving better fatality prevention.

  1. Stand Up to Ownership

    Safety managers' best defense against fatalities may be their willingness to keep the lines of communication open. “We safety professionals have to have the strength of character to say to managers, ‘this is what is happening to the safety management system’ if it is deteriorating,” says Manuele.

  2. Evaluate Near-Hits

    Manuele stresses the importance of implementing near-hit systems to learn from potentially fatal incidents that almost happened. He believes workers should be “encouraged to bring forward things they've noticed about incidents that could cause severe accidents” to prevent such a close call from happening again.

  3. Engage Employees

    According to Shockey, involving employees in the process could help save lives. “We hear [that] with a fairly engaged culture, the chances are the safety aligns,” he says.

  4. Risk Assessment

    “Every company should develop a life-threatening risk program,” Shockey says. Companies that conduct pre-job risk assessments seem to report better results. Risk assessment particularly is important for non-routine tasks.

  5. Training and Education

    The academic world could influence workplace fatalities by offering more safety education. “Every future engineer or every craft apprentice needs to have health and safety training, but few universities include that in their curriculums. Apprentice programs and vo-tech schools do better. In the end, industry has to make up for those gaps by offering training when they come in,” Shockey continues.

  6. Observe Employees at Work

    Shockey also stresses the importance of observing workers on the job to ensure they are engaging in safe practices. “People are starting to realize it's not about the number of observations you do, it's the jobs you observe,” he says. “Maybe you observe new employees or non-routine work; target your observations where the risk is.”

    At Alcoa, for example, Shockey knows roof work is risky, so they target employees working on roofs. “The more you observe, the less often people seem to deviate,” he says.

  7. Rely on Leading Indicators

    These three experts urge safety professionals to study leading indicators, rather than lagging indicators (like total recordable rates) to better assess the risk of fatalities and serious injuries.

  8. Design for Safety

    Ferguson points out it is imperative to plan for safety “in the engineering and design phases, instead of after the fact.”

The Challenge

“The first failure is the fatality,” Shockey says. “The second failure is when we can't learn from it or share it to prevent future catastrophic incidents.”

Conducting research on risk assessment and fatality prevention could help safety professionals learn how to prevent these tragedies. Specifically, Shockey cites a need for better NIOSH data and Bureau of Labor Statistic data, as well as a global database of fatality information and research on risk assessment tools and what triggers the chain of events leading to fatalities. He adds that a national fatality database, which would provide open, anonymous information about fatalities, would be valuable.

“We need research that defines what deficiencies exist in the global interface,” he says.

More research is important because, as Shockey points out, fatalities can be subtle and show up where employers and workers least expect them. That's why Shockey issues a challenge for safety managers to take responsibility.

“I would challenge every safety professional to spend a portion of every day seeking to identify where their next fatal exposure might be,” he says.

A fatality only takes one moment, one misunderstanding or one oversight to occur. Once this moment passes, safety managers, employers and coworkers have a choice: blame the fatality on something out of their control, or take action to avert another death. Until prevention methods are put into place, another unexpected fatality could strike again — and it's a problem that can't be reversed.

“You can fix a broken finger or a cut,” Shockey says, “but you can't fix a fatality.”

European Risk Observatory

While experts like Fred Manuele and Jeff Shockey advocate for risk assessment and hazard recognition programs in the United States, it appears that Europe may be ahead of the game. The European Risk Observatory, part of the European Agency for Safety and Health at Work, works to identify the risks and hazards workers might encounter.

The Risk Observatory aims to:

  • Provide an overview of health at work in Europe;
  • Offer a description of trends and underlying factors;
  • Provide a description of risk factors; and
  • Anticipate changes in work and likely consequences.

The Risk Observatory publishes information about chemical, biological, physical, organizational, social and human risks. In particular, the Risk Observatory pinpoints new and emerging risks to establish preventive action for workplace fatalities.

The European Risk Observatory's website, http://riskobservatory.osha.europa.eu/risks/index.php, states:

“As our society evolves under the influence of new technology and of shifting economic and social conditions, so our workplaces, work practices and production processes are constantly changing. These new work situations bring with them new risks and challenges for workers and employers which in turn demand political, administrative and technical approaches that ensure high levels of safety and health at work.”

2006 U.S. Workplace Fatality Statistics



Agricultural/forestry/fishing/hunting: 29.6

Mining: 27.8

Transportation/warehousing: 16.3

Construction: 10.8


65 and older: 10.8

55 to 64: 4.9

45 to 54: 4.0

35 to 44: 3.6



  • Fishing workers
  • Aircraft pilots, flight engineers
  • Logging workers
  • Structural iron and steel workers
  • Refuse/recyclable material collectors
  • Farmers and ranchers
  • Electrical power-line installers and repairers
  • Roofers
  • Driver/sales workers, truck drivers
  • Misc. agricultural workers


Transportation incidents: 42 percent

Falls: 14 percent

Assaults and violent acts: 13 percent

Contact with object/equipment: 17 percent

Exposure to harmful substances: 9 percent

Fires and explosions: 4 percent

Information provided by the U.S. Bureau of Labor Statistics

About the Author

Laura Walter

Laura Walter was formerly senior editor of EHS Today. She is a subject matter expert in EHS compliance and government issues and has covered a variety of topics relating to occupational safety and health. Her writing has earned awards from the American Society of Business Publication Editors (ASBPE), the Trade Association Business Publications International (TABPI) and APEX Awards for Publication Excellence. Her debut novel, Body of Stars (Dutton) was published in 2021.

Sponsored Recommendations

Free Webinar: ISO 45001 – A Commitment to Occupational Health, Safety & Personal Wellness

May 30, 2024
Secure a safer and more productive workplace using proven Management Systems ISO 45001 and ISO 45003.

ISO 45003 – Psychological Health and Safety at Work

May 30, 2024
ISO 45003 offers a comprehensive framework to expand your existing occupational health and safety program, helping you mitigate psychosocial risks and promote overall employee...

DH Pace, national door and dock provider, reduces TRIR and claims with EHS solution

May 29, 2024
Find out how DH Pace moved from paper/email/excel to an EHS platform, changing their culture. They reduced TRIR from 4.8 to 1.46 and improved their ability to bid on and win contracts...

Case Study: Improve TRIR from 4+ to 1 with EHS Solution and Safety Training

May 29, 2024
Safety training and EHS solutions improve TRIR for Complete Mechanical Services, leading to increased business. Moving incidents, training, and other EHS procedures into the digital...

Voice your opinion!

To join the conversation, and become an exclusive member of EHS Today, create an account today!