CSB Chairperson Rafael MoureEraso says it is critical that OSHA address the recommendations made by the US Chemical Safety Board

Chemical Safety Board Calls OSHA Response to Process Safety Recommendations "Unacceptable"

July 29, 2013
As was expected, the U. S. Chemical Safety Board declared that OSHA’s response to seven Open CSB recommendations on dust, fuel gas and process safety management was “unacceptable.”

The U.S. Chemical Safety Board (CSB) has a “statutory, Congressionally-mandated task to address the sufficiency of OSHA and EPA regulations. That is a key obligation of the CSB and I intend to continue pursuing this mandate vigorously,” said CSB Chairperson Rafael Moure-Eraso.

At a July 25 public meeting in Washington, D.C., members of the U.S. Chemical Safety Board (CSB) addressed the sufficiency of OSHA regulations, declaring the response by OSHA to seven long-standing recommendations – on combustible dust, fuel gas and the Process Safety Management standard – to be “unacceptable.” The board also voted to make the adoption of a combustible dust standard for general industry to be the first priority of its recently established “Most Wanted Safety Improvements” program, which will result in stepped-up advocacy for the measure. 

“Over the years, the CSB has made a number of recommendations to OSHA in the aftermath of tragic accidents that have killed dozens of workers, injured hundreds more, and caused millions of dollars in property damage,” said Moure-Eraso. “We are particularly concerned with the lack of action on a much-needed combustible dust standard.”

Insufficient progress has been made, he said, adding, “Many years have passed in some cases, without a definitive OSHA response.”

The vote by the board designating OSHA’s responses to be “open-unacceptable” means that it strongly believes these recommended regulatory changes are still needed to save lives and prevent accidents in the chemical industry. At the same time, the board voted to keep the recommendations’ status as “open,” because of OSHA’s comments that the agency may consider action in the future. 

Specific Recommendations That Remain Open

The status change action by the CSB concerned the following original recommendations to OSHA: 

Recommendation to ensure coverage under the Process Safety Management (PSM) standard for atmospheric storage tanks that could be involved in a potential catastrophic release as a result of being interconnected to a covered process with 10,000 pounds of a flammable substance. The recommendation was issued in 2002 following the CSB’s investigation of a 2001 explosion of a poorly maintained, corroded storage tank containing spent sulfuric acid and flammable hydrocarbons at the Motiva refinery in Delaware City, Del. A worker was conducting hot work, which ignited vapor through holes in the deteriorated tank. 

Recommendation to revise the PSM standard to require management of change (MOC) reviews for organizational changes such as mergers and acquisitions that may impact process safety. This recommendation, issued in 2007, followed the 2005 explosions and fire at the BP Texas City refinery, which killed 15 workers and injured 180 others.     

Recommendation that OSHA issue a fuel gas safety standard for construction and general industry. This recommendation, issued in June 2010, followed two catastrophic accidents that occurred that year. In one, an explosion caused a roof collapse at the ConAgra Slim Jim facility in Garner, N.C., killing four workers and injuring 67 others. A worker had been attempting to purge new natural gas piping during the installation of an industrial water heater, resulting in a large release of natural gas indoors. In the other, at the Kleen Energy power plant in Middletown, Conn., high pressure natural gas was being used to clean new piping and was released in a congested outdoor area. It ignited, killing six workers and injuring at least 50.    

The board then voted OSHA’s response as “open-unacceptable” to four long-standing recommendations calling for the issuance and expedited action on a comprehensive general industry combustible dust standard:

  • The first of these recommendations was issued in 2006 following a CSB study on the hazards of combustible dust. The study was initiated following a series of major explosions and fires with a large loss of life and numbers of burn injuries. CSB found companies ignoring the hazard or failing to take adequate action to mitigate the danger. The board advocated a new standard be based on existing National Fire Protection Association (NFPA) dust explosion standards. 
  • Three years later, in 2009, following an explosion of combustible sugar dust at the Imperial Sugar Co. in Port Wentworth, Ga., in 2008 that killed 14 workers, CSB called on OSHA to “proceed expeditiously”  on its then-announced intention to conduct rulemaking on a dust standard. 
  • In December 2011, CSB again called on OSHA to move on a dust standard following a series of three iron-dust related flash fires at the Hoeganaes Corp. facility in Gallatin, Tenn. In which five workers lost their lives. CSB called for the inclusion of metal dusts in the scope of any new standard on dust, and recommended that OSHA issue a proposed rule within one year of the issuance of the recommendation.    

“The board has called on OSHA a number of times over the past several years to act on this known, insidious hazard that continues to claim the lives of workers and cause enormous damage and loss of jobs,” said Moure-Eraso. “It’s critical that OSHA address the recommendations.”   

About the Author

Sandy Smith

Sandy Smith is the former content director of EHS Today, and is currently the EHSQ content & community lead at Intelex Technologies Inc. She has written about occupational safety and health and environmental issues since 1990.

Sponsored Recommendations

10 Facts About the State of Workplace Safety in the U.S.

July 12, 2024
Workplace safety in the U.S. has improved over the past 50 years, but progress has recently stalled. This report from the AFL-CIO highlights key challenges.

Free Webinar: ISO 45001 – A Commitment to Occupational Health, Safety & Personal Wellness

May 30, 2024
Secure a safer and more productive workplace using proven Management Systems ISO 45001 and ISO 45003.

ISO 45003 – Psychological Health and Safety at Work

May 30, 2024
ISO 45003 offers a comprehensive framework to expand your existing occupational health and safety program, helping you mitigate psychosocial risks and promote overall employee...

Case Study: Improve TRIR from 4+ to 1 with EHS Solution and Safety Training

May 29, 2024
Safety training and EHS solutions improve TRIR for Complete Mechanical Services, leading to increased business. Moving incidents, training, and other EHS procedures into the digital...

Voice your opinion!

To join the conversation, and become an exclusive member of EHS Today, create an account today!